Pelistuds

Specially heat treated, which ensures maximum toughness, strength and rust resistance

Stainless Steel Studs

Available with either a fishtail or chisel shank. Designed and shaped to prevent twisting after installation. To assist skid resistance a serrated face is also available (chisel shank only).

Aluminium

Conforms to B.S. 1490:2018. Supplied with a raised profile to assist skid resistance, and fishtail shank.

All Studs meet the requirements of B.S. 8442:2015 and the Traffic Signs Regulations & General Directions 2002

MEASUREMENTS, TYPE & WEIGHTS
SURFACE OF STUD (Square)				SHANK OF STUD
OUR REF	METAL	Nom Size mm	TYPE	SHAPE	mm
18600S	Aluminium	102 x 102	Raised Face	Fishtail	75±6
18700S	Stainless Steel	102 x 102	Plain Face	Fishtail	75±6
18750S	Stainless Steel	102 x 102	Plain Face	Chisel	75±6
18755S	Stainless Steel	102 x 102	Serrated Face	Fishtail	75±6

Installation

Drill a hole 32mm diameter to a depth of 80mm. Clear away dust from interior of hole and surface of the road to be covered by the head of the pelistud.
Note: For concrete surfaces it is necessary to prime the hole and surrounding road surface with bitumen emulsion primer prior to grouting.
Fill the hole fully with hot bitumen grout and IMMEDIATELY insert the pelistud shank and firmly press the head to the road surface, taking care that the stud is properly aligned.
If necessary, pressing may be supplemented by light tamping with a wood or rubber mallet or similar. ON NO ACCOUNT SHOULD THE STUD BE HAMMERED.

The surplus of bitumen will be forced out of the hole by the ingoing shank to form a bed for the head. Any surplus bitumen beyond the area of the marker should be trimmed off.

Light Dome Road Products (A division of Industrial Rubber Ltd)
4 Fielder Drive Newgate lane Industrial Estate FAREHAM
Hampshire PO14 1JE
Tel: 44(0)1329-284780 Fax: +44(0)1329-829485
Email: sales@lightdome.co.uk

Manufacturers of the depressible Road Stud
In partnership with our Sister Companies in China to achieve Low Cost Manufacturing Abroad